SupportPages Writer writes this project's articles with a coding agent, and you decide which one, which model it runs, and how hard it thinks. All three are set from one command in your project folder. ## Prerequisites - This project is already set up. If it isn't, run `wtfm init` in the project folder first. - Your coding agent is connected. If Claude Code or Codex isn't linked yet, run `wtfm setup`. - A terminal open in your project folder. ## Steps ### Step 1: Open this project's settings Run `wtfm configure` in your project folder. ```bash wtfm configure ``` SupportPages Writer opens a short menu. Choose **Coding agent and model**. ![Open this project's settings](https://help.wtfm.sh/rails/active_storage/blobs/proxy/eyJfcmFpbHMiOnsiZGF0YSI6MTI0ODMsInB1ciI6ImJsb2JfaWQifX0=--5a34d4a7e07bbe9a8df12931da198163dae3dd0c/block_open-settings.png) ### Step 2: Choose the coding agent If both Claude Code and Codex are connected, you'll be asked which one should write this project's articles — pick **Claude Code** or **Codex**. When only one agent is connected, it's used automatically and this question is skipped. ### Step 3: Choose the model Next you pick the model. SupportPages Writer lists what your coding agent offers and marks the one it recommends for faithful mockups. Move the highlight with the arrow keys, or type to filter, then press Enter. ![Choose the model](https://help.wtfm.sh/rails/active_storage/blobs/proxy/eyJfcmFpbHMiOnsiZGF0YSI6MTI0ODcsInB1ciI6ImJsb2JfaWQifX0=--9322fb9c3f3dca3c16fc97e72c1183889d4200d1/block_choose-model.png) ### Step 4: Set the reasoning effort Reasoning effort is how much time the model spends thinking before it writes. **Medium** is the recommended starting point for mockups; higher settings take longer. Pick an effort and press Enter to save it for this project. ![Set the reasoning effort](https://help.wtfm.sh/rails/active_storage/blobs/proxy/eyJfcmFpbHMiOnsiZGF0YSI6MTI0OTgsInB1ciI6ImJsb2JfaWQifX0=--ae0837be05a4f92421521488f3042fdb4e861c96/block_set-effort.png) ## Tips - These settings belong to this project only — your other projects keep their own agent and model. - Lighter models may simplify layouts or miss interface details, so stick with the recommended model when article quality matters. - Model and effort are separate: the same model thinks harder on High than on Low. - You can run `wtfm configure` again whenever you want to change any of them. ## Summary Run `wtfm configure`, choose **Coding agent and model**, then pick a model and an effort. Match a stronger model and Medium effort to the articles that need to look sharp, and keep a lighter setup for quick drafts.